An extended durability formulation which requires less maintenance than
conventional finishes. This product exhibits a high gloss that is long lasting
and extremely hard yet flexible. This product is great for use on all types of
floor surfaces from resilient tile to stone. This product responds well with any
low or high speed maintenance program.

DIRECTIONS
INITIAL APPLICATION
1. Remove all old wax and floor finish with appropriate stripper.
2. Rinse the floor thoroughly (at least twice) with clean water.
3. Repeat steps 1-2 if all finish is not removed. Allow floor to dry.
4. Apply 3-4 thin coats of this product using a clean synthetic mop, allowing
a minimum of 30 minutes between coats.
5. Apply additional coats in the same manner, allowing at least 30 minutes
drying time between coats.
6. For very porous floors, an initial coat of floor sealer is recommended.
NOTE: Temperature, humidity and air movement affect curing time.
To avoid contamination, do not return any unused material to original
container.
ROUTINE MAINTENANCE
1. Sweep or dust mop as necessary.
2. Damp mop with proper cleaner following label instructions. For
accumulated soil, lightly scrub as needed.
3. After cleaning, spray buffing or burnishing may also be done once loose
dirt and dust has been swept up.
4. Additional coats may be applied if needed.

FOR PROPER PERFORMANCE USE ONLY WHEN PRODUCT TEMPERATURE
AND FLOOR TEMPERATURE ARE 50ºF OR HIGHER.
WARNING: Do not allow wet floor areas to be open to foot traffic. Wet shoes
or wet spots can create a slippery condition. Wet floor areas should be
cordoned off until dry for traffic.

Coverage: 2,000–2,500 square feet per gallon.
 
Available in Gallons and 5 Gallon Pails